We need a pot in which you want to plant a tree or some flowers. This may be an ordinary flower clay pot, but I always take a pot for baking. Firstly they are cheaper than flowers (which is after all paradox), and secondly there is a cap which can also be useful. MK on the use of such caps will soon be submitted to your court. Surface on which we gypsum either a table or something else to advance to close newspapers, so as not to slap. Cap, as I have said is clear, it is useful to us later. Anu Saad is full of insight into the issues. Inside the pot no holes for utekaniya water as this whole pot for cooking and our gypsum nowhere to be expand when solidification.

Therefore, we take we do not need paper and a mnemonic to make it as much as possible and then twists it. Now be laid to our paper in the pot for each stenochke, and when will harden plaster it will expand but the pressure is not on the walls of the pot, and pressing it onto paper, and our pot will remain unharmed, and even the paper substrate will facilitate the pot. Can you imagine what it would be difficult if it all filled with plaster, and so he still quite light but steady. Once you put enough paper and left in the center spot for your tree root or a flower starting to grow gypsum. Do not forget to try a suit on the length of the root of a tree or flower to the pot and left for him. Gypsum is diluted with water, the resulting mass should be the consistency of thick cream. Holding the barrel our tree begin to pour into the pot gypsum. If there are leaves should be on top of the pot then they need to collect "a bunch" and it is desirable to close the plastic wrap or foil. n.

So fill the pot with plaster to the top. After that zagipsovyvaem trunk of our flower, in this case I put in a pot of orchid. A look at the result obtained in the cat, reserve our state flower for 24 hours. Then you can paint and give the necessary shape our leaves, and the right stuff. That's all, hope this Master Class you will be useful. I wish you good luck in creativity!